This case is the Antec P180 with a 4 piece PC Wrap kit. This kit was created to exact size
but most kits are universal and you simply trim them down a bit to fit.






?
First tape down the side side piece so it cannot move. Then line up your graphic to the piece you are applying it to and then taping it down exactly where you want it. Tape it right down the middle. This is called the hinge method and allows you to install one half at a time and for better alignment.


Make sure your side panel is clean before applying skin. Remove the backing paper from the skin until you get to the hinged tape section. Make sure you are removing the section that is NOT holding the panel down with tape.






After half of the backing paper is pulled away carefully rip it off showing the sticky vinyl facing towards you. Star from the hinged section and start to squeegee the vinyl towards the end until its full applied. Remove as many bubbles as you can with the squeegee.



Remove the tape that was hinged, also remove the tape holding the panel down and apply it to the other side of the panel.